high-pass filter


Also found in: Thesaurus, Medical, Encyclopedia, Wikipedia.
Related to high-pass filter: low-pass filter

high-pass filter

 (hī′păs′)
n.
A filter designed to transmit electromagnetic frequencies above a certain value, while excluding those of a lower frequency.
American Heritage® Dictionary of the English Language, Fifth Edition. Copyright © 2016 by Houghton Mifflin Harcourt Publishing Company. Published by Houghton Mifflin Harcourt Publishing Company. All rights reserved.

high-pass filter

n
(Electronics) electronics a filter that transmits all frequencies above a specified value, substantially attenuating frequencies below this value. Compare low-pass filter, band-pass filter
Collins English Dictionary – Complete and Unabridged, 12th Edition 2014 © HarperCollins Publishers 1991, 1994, 1998, 2000, 2003, 2006, 2007, 2009, 2011, 2014
ThesaurusAntonymsRelated WordsSynonymsLegend:
Noun1.high-pass filter - a filter that passes frequencies above a certain value and attenuates frequencies below that value
filter - an electrical device that alters the frequency spectrum of signals passing through it
Based on WordNet 3.0, Farlex clipart collection. © 2003-2012 Princeton University, Farlex Inc.
References in periodicals archive ?
Fractional-order high-pass filter with electronically adjustable parameters.
Koton, "Fractional-order high-pass filter with electronically adjustable parameters", in Proc.
Usually, to highlight the Ts dynamics, a low-pass filter is designed, and to highlight the T1 dynamics, a high-pass filter is designed.
Audio processing capabilities include powerful dynamics and effects, such as a high-pass filter, gate, compressor/limiter, 3-band EQ, delay and the ability to select audio-follows-video channels.
Figure 9 shows that responses of proposed VDBA based filters such as Low-Pass Filter (LPF), High-Pass Filter (HPF), Band-Pass Filter (BPF), and Band-Reject Filter (BRF).
At one limiting case, BPF1 is a low-pass filter, and BPF2 is a high-pass filter. Self-pulsation occurs for a fixed EDFA pump power, by reducing the spectral separation between the BPFs, by red-shifting BPF2.
(ii) If the input voltage is applied at node [v.sub.in2] while nodes [v.sub.in1] and [v.sub.in3] are grounded, the noninverting high-pass filter is achieved.
The transfer functions of the low-pass filter H0 (w) and the high-pass filter H1(w) are constructed as follows [21]:
A high-pass filter eliminates the baseline drift, which is caused by breathing and physical movement.
The high-pass filter was set to 2 kHz rather than 500 Hz to avoid recording composite potentials because the 37-mm CNE had a larger recording area than the SFE (2).

Full browser ?